North Carolina-based Semiconductor Research Corporation (SRC) and Singapore’s Silicon Cloud International (SCI) are launching a new program aimed at globally advancing integrated circuit (IC) design education and research. The program will focus on increasing the quantity of IC designers in university systems worldwide, and enhancing expertise in secure cloud computing architecture.
In semiconductor-based components, high mobility of charge-carrying particles is...
Engineers at the Univ. of Arkansas have designed...
At the 2014 Symposium on VLSI Technology in...
The basic element of modern electronics, namely the transistor, suffers from significant current leakage. By enveloping a transistor with a shell of piezoelectric material, which distorts when voltage is applied, researchers in the Netherlands were able to reduce this leakage by a factor of five compared to a transistor without this material.
Modern supercapacitors store ten times less energy than a lithium-ion battery but can last a thousand times longer. The main drawback of supercapacitors, however, is the inability to cope with stresses such as pressure and vibration. Researchers have developed a new supercapacitor that operates flawlessly in storing and releasing electrical charge while subject to stresses or pressures up to 44 psi and vibrational accelerations over 80 g.
A new approach to integrated circuits, combining atoms of semiconductor materials into nanowires and structures on top of silicon surfaces, shows promise for a new generation of fast, robust electronic and photonic devices. Engineers in California have recently demonstrated 3-D nanowire transistors using this approach that open exciting opportunities for integrating other semiconductors, such as gallium nitride, on silicon substrates.
Germanium monosulfide (GeS) is emerging as one of the most important class "IV–VI" semiconductor materials with potential in optoelectronics applications for telecommunications and computing. Adding a new element of control to preparation of this material, researchers in China have found a convenient way to selectively prepare GeS nanostructures, including nanosheets and nanowires, that are more active than their bulk counterparts
Until now, it has been hard to couple light generation into layered semiconductor systems. Scientists in Austria have recently solved this problem using metamaterials, which are able to manipulate light in the terahertz range due to their special microscopic structure. This represents the first combination of metamaterials and quantum cascade structures.
Commercial demand is driving high-tech research and development in micro-optoelectromechanical systems (MOEMS) for diverse applications such as space exploration, wireless systems, and healthcare. A new special section on Emerging MOEMS Technology and Applications in the current issue of the Journal of Micro/Nanolithography, MEMS, and MOEMS discusses these recent breakthrough achievements.
Existing transistors act as electronic switches, altering current flow through a semiconductor by controlling the bias voltage across the channel region. A new electronic component, called a source-gated transistor, has been developed in the U.K. and exploits physical effects such as the Schottky barriers at metal-semiconductor contacts. This innovation could improve the reliability of future digital circuits used within flexible gadgets.
Organic solar cells are a compelling thin-film photovoltaic technology in part because of their compatibility with flexible substrates and tunable absorption window. Belgium-based chipmaker imec has set a new conversion efficiency record of 8.4% for this type of cell by developing fullerene-free acceptor materials and a new multilayer semiconductor device structure.
Light-emitting diodes (LEDs) are durable and save energy. Now, researchers have found a way to make LED lamps even more compact while supplying more light than commercially available models. The key to this advance are a new type of transistors made of the semiconductor material gallium nitride.
Researchers at IBM have set a new record for data transmission over a multimode optical fiber, a type of cable that is typically used to connect nearby computers within a single building or on a campus. The data was sent at a rate of 64 Gb/s over a cable 57-m long using a type of laser called a vertical-cavity surface-emitting laser. This rate is 2.5 times faster than the capabilities of today's typical commercial technology.
European scientists from both academia and industry have begun an ambitious new research project focused on an alternative approach to extend Moore's Law. The research project, coordinated IBM Research in Zurich and called COMPOSE³, is based on the use of new materials to replace today's silicon, and on taking an innovative design approach where transistors are stacked vertically, known as 3-D stacking.
Researchers at Tyndall National Institute in Ireland have produced the first ever atom-by-atom simulation of nanoscale film growth by atomic layer deposition (ALD), a thin-film technology used in the production of silicon chips. The accomplishment required the acquisition of the complete set of hundreds of ALD reactions at the quantum mechanical level.
Continuous miniaturization in microelectronics is nearing physical limits, so researchers are seeking new methods for device fabrication. One promising candidate is a DNA origami technique in which individual strands of the biomolecule self-assemble into arbitrarily-shaped nanostructures. A new simpler strategy combines DNA origami with self-organized pattern formation to do away with elaborate procedures for positioning DNA structures.
New research hints that nanodevices in microcircuits can protect themselves from heat generation through the transformation of nanotransistors into quantum states. The finding, demonstrated in nanoscale semiconductors devices, could boost computing power without large-scale changes to electronics.
Researchers in Ireland and Germany have discovered a novel solid state reaction which lets kesterite grains grow within a few seconds and at relatively low temperatures. The work points towards a new pathway for the fabrication of thin microcrystalline semiconductor films without the need of expensive vacuum technology.
Superconducting quantum interference devices (SQUIDs) are incredibly sensitive magnetic flux sensors which have been limited in their applications because of thermal challenges at ultralow temperatures. Researchers in the U.K. have succeeded in overcoming this difficulty by introducing a new type of nanoscale SQUID based on optimized proximity effect bilayers.
The goal of fabricating fixed-size one-dimensional silica structures and being able to precisely control the diameter during growth has long eluded scientists. Now, Oak Ridge National Laboratory researchers Panos Datskos and Jaswinder Sharma have demonstrated what they describe as the addressable local control of diameter of each segment of the silica rod.
Flickering façades, curved monitors, flashing clothing, fluorescent wallpaper, flexible solar cells—and all printable. This is no make-believe vision of the future; it will soon be possible using a new printing process for organic light-emitting diodes.
Belgian nanoelectronics research center Imec and JSR, a materials company based in Tokyo, Japan, announce that they have successfully used JSR’s innovative PA (Photo-patternable Adhesive) material for wafer-scale processing of lab-on-chip devices. Using this material, imec has processed microfluidic cell-sorter devices, merging microheaters and sensors with wafer-scale polymer microfluidics.
If consumer electronics companies are to be believed, someone on your holiday shopping list is just dying for a wristwatch that displays message alerts and weather updates. Samsung and Sony have them, Google and Apple are rumored to be developing them. But some experts say it's a product in search of a market, and an expensive one at that.
An industry-academic partnership has created two different optical components that can be fabricated within the same processes already used in industry to create today’s electronic microprocessors. The modulators, which are structures that detect electrical signals and translate them into optical waves, use light instead of electrical wires to communicate with transistors on a single chip.
A new method developed in Germany makes it possible to manufacture ultra-thin saw wires by placing diamond on carbon nanotubes. The new invention is designed to cut through silicon wafers with minimum kerf, or “sawdust”, loss that is the unavoidable result of current tools used in semiconductor wafer fabrication.
A study of the photovoltaic industries in the U.S. and China shows that China's dominance in solar panel manufacturing is not driven solely by cheaper labor and government support, but by larger-scale manufacturing and resulting supply-chain benefits. Researchers say a balance could be achieved through future innovations in crystalline solar cell technology.
A collaboration of scientists from the Univ. of Minnesota and the National Renewable Energy Laboratory have developed a new method to use an ionized gas, called nonthermal plasma, to produce silicon nanocrystals and cover their surfaces with a layer of chlorine atoms. This method allows production of stable silicon inks without organic ligand molecules and also greatly enhances conductivity.
Researchers in California have demonstrated that indium phosphide, a III-V compound, can be grown on thin sheets of metal foil in a process that is faster and cheaper than traditional methods, yet still comparable in optoelectronic characteristics. Indium phosphide is among the high-performance solar converter, but has been up to 10 times as expensive as silicon to integrate in photovoltaic cells.
- Page 1