The humble sewing machine could play a key role in creating "soft" robotics, wearable electronics and implantable medical systems made of elastic materials that are capable of extreme stretching.
New stretchable technologies could lead to innovations including robots that have human-like sensory skin and synthetic muscles and flexible garments that people might wear to interact with computers or for therapeutic purposes.
"However, you would need a low-cost, highly stretchable electrical conductor to interconnect sensors and other components in these applications," said Babak Ziaie, a Purdue Univ. professor in the School of Electrical and Computer Engineering and Weldon School of Biomedical Engineering.
Other researchers are pursuing approaches that require the use of complicated and expensive microfabrication techniques or exotic technologies such as liquid-metal-filled microchannels and ultra-thin wires prone to breaking.
Now, a Purdue team has come up with a far simpler, less-costly alternative: Use a standard sewing machine to create ultra-stretchable interconnects out of conventional wire. The wire is sewn in a zigzag pattern and embedded in a rubbery, stretchable "elastomer" called Ecoflex, manufactured by Smooth-On Inc.
The researchers have demonstrated that interconnect is capable of stretching 500% of its length.
"This compares to only a few percent for an ordinary metal connection," said Ziaie, leading the research with doctoral student Rahim Rahimi. "The structures are also highly robust, capable of withstanding thousands of repeated stretch-and-release cycles."
Since it was not practical to sew the wire directly into the rubbery elastomer because of its squishy nature, the researchers developed a technique to first sew the wire into a sheet of polyethylene terephthalate (PET), the same material used to make transparencies for overheard projectors. The zigzag wire pattern was stitched to the PET sheets with a water-soluble thread. Then the rubbery stretchable polymer was poured over the sheet, encasing the wire as it solidified. Warm water was used to dissolve the thread, and the flexible polymer was separated from the PET sheet with the wire embedded in it.
The researchers used their technique to demonstrate a stretchable "inductive strain sensor" for monitoring expansion of an inflatable urinary catheter balloon. Strain gauges measure how much a material stretches or deforms. Because conventional strain gauges are made of rigid metal film, they can't measure more than a small percentage of the deformation before breaking, whereas a soft strain gauge could continue stretching with the material.
Source: Purdue Univ.