The mechanical properties of natural joints are considered unrivalled. Cartilage is coated with a special polymer layer allowing joints to move virtually friction-free, even under high pressure. Using simulations on Jülich’s supercomputers, scientists from Forschungszentrum Jülich and the Univ. of Twente have developed a new process that technologically imitates biological lubrication and even improves it using two different types of polymers. The results will be published in the science journal Nature Communications.
Lubricants are required wherever moving parts come together. They prevent direct contact between solid elements and ensure that gears, bearings, and valves work as smoothly as possible. Depending on the application, the ideal lubricant must meet conflicting requirements. On the one hand, it should be as thin as possible because this reduces friction. On the other hand, it should be viscous enough that the lubricant stays in the contact gap. In practice, grease and oils are often used because their viscosity increases with pressure.
Biological lubrication in contrast is much more efficient. In joints, a thin, watery solution prevents friction. The thin film stays where it should thanks to a trick of nature. A polymer layer is anchored to the cartilage at the end of bones. Polymers are a string of densely packed, long-chain molecules. They protrude from the cartilage and form "polymer brushes" which attract the extremely fluid lubricant and keep it in place at the contact point.
Over the last 20 years, numerous attempts have been made to imitate the natural model technically. But with no resounding success. The tentacle-like polymers on surfaces opposite each other tend to get tangled up in each other. They slow each other down and detach from the surfaces. In technical systems, individual polymers that become detached are difficult to replace as they do not possess the same self-healing mechanisms as in a natural organism.
Jülich physicist Prof. Martin Müser came up with the idea of using two different polymers at the contact point to prevent the polymers becoming entangled. "Using supercomputers, we simulated what would happen if we applied water-soluble polymers to one side and water-repellent polymers to the other side," says head of the NIC (John von Neumann Institute for Computing) group Computational Materials Physics at the Jülich Supercomputing Centre (JSC). "This combination of water-based and oil-based liquids as a lubricant reduced the friction by two orders of magnitude—around a factor of 90—compared to a system comprising just one type of polymer."
Measurements with an atomic force microscope at the Univ. of Twente in the Netherlands verified the results. "The two different phases of the liquid separate because they repel each other. This simultaneously holds the polymers back and prevents them from protruding beyond the borders," says Dr. Sissi de Beer, who recently moved from Müser’s group to the Univ. of Twente.
The low-friction two-component lubricant is interesting for numerous applications. One example are simple piston systems, like syringes, which are used to precisely administer even tiny amounts of a drug. Above all, the new process could provide low-friction solutions where high pressures and forces occur locally—for example, axle bearings and hinges. For the most common lubricant—engine oil—an alternative has yet to be found; conventional polymer brushes are unable to withstand the high temperatures.
Sissi de Beer, Edit Kutnyanszky, Peter M. Schön, G. Julius Vancso, Martin H. Müser. Solvent induced immiscibility of polymer brushes eliminates dissipation channels. Nature Communications, published online on 14 May 2014, doi 10.1038/ncomms4781
Source: Forschungzentrum Juelich