Explosion unlikely to slow gas plant development

Posted In: Manufacturing

By MARK WILLIAMS - Associated Press Writers - Associated Press

Monday, February 8, 2010

Loading...

The explosion that killed five people in the state of Connecticut won't slow the development of natural gas power plants. But it will likely lead to more scrutiny of a technique used to clear air from gas lines.

The accident is the latest in a series of deadly blasts over the last decade connected to natural gas, a fuel increasingly being counted on to power the nation's energy future.

The blast in Middletown, Connecticut on Sunday, which also injured at least a dozen people, happened as workers were purging gas lines of air, but the exact cause remained under investigation.

Purging is the same process linked to an explosion in North Carolina last year that killed four workers at a Slim Jim beef jerky factory.

The problem of purging gas has become serious enough that the U.S. Chemical Safety Board voted 2-1 last week to approve new safety recommendations for how it should be done. The federal agency has urged workers to vent gases outdoors and use detectors to monitor gas levels while purging gas lines. If that's not possible, all nonessential workers should leave the area.

It is not clear what the conditions were in Connecticut when the explosion occurred. A team sent by the Safety Board to the site Monday was turned away by local police, said Daniel Horowitz, the agency's spokesman. The Occupational Safety and Health Administration was also expected to send a team to the site Monday to investigate.

The explosion at the plant comes as power generators are increasingly relying on natural gas to produce electricity, and the use of gas is growing to power factories and heat homes.

Gas is used to make about a fifth of America's electricity. That's expected to grow to 26 percent by 2018 as older, coal-fired plants are retired. There are 35 gas-fired power plants in the U.S. either under construction or built but not yet operational.

Experts say the explosion will not deter growing reliance on natural gas, noting that with any fossil fuel there is the risk of a blast.

David Boonin of the National Regulatory Research Institute, a group that advises utility regulators, said, "I'm more concerned about volatile gas prices than gas safety."

Cameron Horwitz, who tracks natural gas for SunTrust Robinson Humphrey said the accident may lead to more precautions on how it is handled.

A Safety Board team also examined the explosion on June 9 in the Raleigh, North Carolina, suburb of Garner that killed four and injured dozens working at the ConAgra Foods Inc. plant.

"I would anticipate that the team will be examining what happened in Middletown to see if there are any similarities," Horowitz said.

During that investigation of the Slim Jim plant, the Safety Board identified similar blasts, including an explosion in 1999 at a Ford Motor Co. power plant in Dearborn, Michigan, that killed six, injured 38 and caused $1 billion in property loss.

John Bresland, the board's chairman, said last week in North Carolina that the safety board hadn't been able to identify a trend in the problems because they had not gone to investigate the other explosions.

"Unfortunately, it took the tragedy here in Garner to get us here and to make the recommendations that we are making," he told reporters.

___

Baker reported from Raleigh, North Carolina.

JOIN THE DISCUSSION
Rate Article:  Average 0 out of 5
Register or log in to comment on this article!

0 Comments

Add Comment

Text Only 2000 character limit

Page 1 of 1

New To Market

more

P2i showcases liquid repellent nano-coating for hearing aids
P2i showcases liquid repellent nano-coating for hearing aids

At the AudiologyNOW! 2010 show in San Diego next month, UK-based coatings company P2i will display their relatively new Aridion liquid-repellant nano-coating. Designed for exposure to humidity or sweat, the polymer layer is applied by a pulsed ion gas process that lower’s the hearing aid’s surface energy, coaxing water away from delicate components.

Submersible FlowCAM catches particle images and data in-situ and real-time

Fluid Imaging Technologies recently introduced its Submersible FlowCAM particle and cell imaging and analysis system at Ocean Sciences 2010 in Portland, Ore. The remote sensing platform can be used for continuous, unattended monitoring tethered to research vessels or autonomous submersibles.

Tools & Technology

more

Benchtop NMR analyzer
Benchtop NMR analyzer

Oxford Instruments America, Inc.’s Magnetic Resonance Group released the second generation of its MQC analyzers.

Software solution for microarray image analysis

BioDiscovery Inc. released ImaGene 9.0 for microarray image analysis. The new features include improved memory performance for the latest high density arrays, streamlined processing pipeline focused on image quantification and intensity extraction, and new modular design with options to add modules for analysis of gene/miRNA expression or CGH data.

Advertisement

Advertisement