Drinking water pulled from thin air

Posted In: Alternative Energy Technology | Atmospheric Sciences | Alternative Fuels & Energy | Atmospheric Sciences | Clean Air Policy | Fraunhofer-Gesellschaft

newsvine diigo google
slashdot
Share
Loading...
Not a plant to be seen, the desert ground is too dry. But the air contains water, and research scientists have found a way of obtaining drinking water from air humidity. The system is based completely on renewable energy and is therefore autonomous.

Cracks permeate the dried-out desert ground, the landscape bears testimony to the lack of water. But even here, where there are no lakes, rivers or groundwater, considerable quantities of water are stored in the air. In the Negev desert in Israel, for example, annual average relative air humidity is 64%—in every cubic meter of air there are 11.5 milliliters of water.

Research scientists at the Fraunhofer Institute for Interfacial Engineering and Biotechnology IGB in Stuttgart working in conjunction with their colleagues from the company Logos Innovationen have found a way of converting this air humidity autonomously and decentrally into drinkable water. “The process we have developed is based exclusively on renewable energy sources such as thermal solar collectors and photovoltaic cells, which makes this method completely energy-autonomous. It will therefore function in regions where there is no electrical infrastructure,” says Siegfried Egner, head of department at the IGB. The principle of the process is as follows: hygroscopic brine—saline solution which absorbs moisture—runs down a tower-shaped unit and absorbs water from the air. It is then sucked into a tank a few meters off the ground in which a vacuum prevails. Energy from solar collectors heats up the brine, which is diluted by the water it has absorbed. Because of the vacuum, the boiling point of the liquid is lower than it would be under normal atmospheric pressure. This effect is known from the mountains: as the atmospheric pressure there is lower than in the valley, water boils at temperatures distinctly below 100 degrees Celsius. The evaporated, non-saline water is condensed and runs down through a completely filled tube in a controlled manner. The gravity of this water column continuously produces the vacuum and so a vacuum pump is not needed. The reconcentrated brine runs down the tower surface again to absorb moisture from the air.

“The concept is suitable for various sizes of installation. Single-person units and plants supplying water to entire hotels are conceivable,” says Egner. Prototypes have been built for both system components—air moisture absorption and vacuum evaporation—and the research scientists have already tested their interplay on a laboratory scale. In a further step the researchers intend to develop a demonstration facility.

Original Release

SOURCE: Fraunhofer-Gesellschaft

0 Comments

blog comments powered by Disqus

New To Market

more

JEOL to launch world's smallest solid-state NMR probe
JEOL to launch world's smallest solid-state NMR probe

According to JEOL Resonance, a new benchmark for resolution and benchmark will be set with its introduction next week of a new 0.75-mm solid state nuclear magnetic resonance (NMR) probe. The probe is capable of high resolution sample analysis by spinning the sample at 110 kHz, the world's fastest spinning speed for NMR.

Energy Harvesting Subsystems for Wireless Sensors

Nextreme Thermal Solutions has developed two new energy harvesting subsystems for the plumbing and HVAC industries. The subsystems are the latest additions to Nextreme's Thermobility energy harvesting platform that uses thin-film thermoelectric technology to convert available thermal energy into electric power for a variety of autonomous self-powered applications.

Tools & Technology

more

Plates, Stirrers Feature Five or Nine Positions
Plates, Stirrers Feature Five or Nine Positions

Torrey Pines Scientific Inc. has announced a new line of multi-position analog stirring hot plates and stirrers featuring five or nine stirring positions.

Phree Phospholipid Removal Plates

Phenomenex Inc. has introduced Phree phospholipid removal plates for fast cleanup of plasma samples in pharmaceutical and clinical research laboratories. In one step, Phree removes both proteins and phospholipids and delivers the prepared plasma to a collection plate.

Advertisement

Advertisement

Top Stories and Headlines
EVERY DAY!

FREE Email Newsletter